Mitsubishi L200/ Triton/ Fiat Fullback (2016-) Rear Kit | Boss Air
£695.00
This kit fits the 5th Generation Mitsubishi L200 KJ, KK or KL (2015-). The L200 is also known as the Mitsubishi Triton and the Fiat Fullback – this kit fits all models of the Triton and the Fullback from 2016 onwards.
It is a rear-end load support air suspension kit, which means it is installed in addition to the vehicle’s original leaf spring.
It can be inflated simply through Schrader (tyre) valves, or through an air management system of your choice (see ‘Options’ tab below for more info).
See the ‘Description’ tab below for more information on the kit, including exactly what you get in the box.
This is a rear-end air suspension kit. Based on several decades specialising in air suspension, we believe that this is the highest-quality load support kit on the market for the Mitsubishi L200 (2016-). The kit:
Is a practical bolt-on installation which is rated as DIY or local garage fit
Improves stability and handling and reduces roll
Recovers lost suspension motion to improve ride quality
Lifts sagging vehicles to reduce or prevent grounding
Is superb for help with towing
Can prevent broken springs
Can help pass an MOT if your vehicle is low
Can help re-rating for heavier capacity on some vehicles
The kit comes with:
2 x BOSS Extreme Series Double Bellow Airbags
4 x brackets (2 upper & 2 lower)
Mounting hardware
Quality SAE J844 Australian Government-approved airline
Dual Schrader valves mounted in stainless panel
Instructions for fitting
Boss Extreme series airbags are rated at 1136 kgper side and have been government approved tested to over 750psi.
All Boss airbags are manufactured by Boss Air Suspension and are branded Boss. Beware of unbranded airbags, usually coming from China from other companies.
Average dual cab pickup will run around 15-45 psi depending on load.
Boss has sold over 13000 load-assist kits in Australia, proven over time with 4WD enthusiasts, Mining companies, Tradies, 4WD Tour Operators as well as in Agricultural Vehicles, Trailers and motorhomes, limited only to your imagination.
To get the best performance from your kit inflate airbags just enough to achieve a level ride height. By doing this you are also allowing all of the suspension components to share the extra load of the vehicle and not putting any unnecessary pressure on any one individual part of your vehicles suspension.
Options
Heavy pick-ups with fixed loads are often fitted with simple control systems, such as Schrader (tyre) valves or Schrader valves and a gauge block. These work very well for vehicles carrying a fixed load/weight.
When the load in your motorhome varies significantly, On-Board Air (OBA) is normally required. This enables you to get the very best from your kit at all times. OBA allows the ride height to be adjusted for road, weather and load conditions, and for those experiencing grounding conditions it allows the absolute maximum lift to be achieved when needed (for instance on ferries, petrol stations and rough site entrances). The vehicle can then be returned to the most comfortable setting.
OBA is also great for towing, where loads are added or removed, or for commercial vehicles that start the working day at one weight and end it at another as deliveries are completed.
OBA packages come in various specifications as outlined below. If in doubt, please contact us via e-mail or phone.
Schrader valve kits
The simplest kit available. One fitting at the airbag, a length of line and a Schrader (tyre) valve at the other end. The valve can be fitted anywhere convenient to the user and can be inflated anywhere a tyre can be inflated (e.g. garage, petrol station).
Recommended for: Vehicles with a fixed load that does not alter and users who want an entry-level system. Ideal for motorhomes because they are always very heavy vehicles but the weight does not usually vary considerably. Users need to find an air source (i.e. at a garage or petrol station) to adjust the pressures (emergency tyre inflators rarely last if asked to inflate air suspension regularly.)
Schrader valve gauge blocks
A gauge block with two Schrader valves and two gauges. No moving parts to go wrong, such as taps or levers. Pressure can be monitored from the gauge block, which can be fitted anywhere convenient. Several versions available. This option does not come with a plate that can be fitted to the dashboard.
Recommended for: Vehicles with a fixed load as above but with two gauges for those who always want to know the pressure in the bags.
Budget Duty OBA
Includes a 10% duty cycle compressor, maximum 105 PSI. Comes with an OBA hook-up kit to match the compressor, which comes with an on/off button to get to pressure. Also comes with a cross-locking mini valve. Please note that although the left and right air bags are independent, they cannot be set to different pressures. Does not include a tank.
Recommended for: Infrequent adjustment. When the load varies, due to towing or adding payload to a commercial vehicle, air-managed solutions get the very best from the system. This is an entry-level, compressor control package.
Economy Duty OBA
Includes a low duty cycle compressor, maximum 130 PSI. Please note: The left and right air bags are independent but cannot simply be set to different pressures at the touch of a button. Higher specification than the entry-level kit, making this kit very good value for money.
This kit is simple to install and operate. As the video below shows, it has a single button to simultaneously lift both sides. To deflate the air and lower the vehicle requires use of the Schrader valves at the bottom of the controller.
Recommended for: Users who want a better controller with a heavier-duty compressor but who perhaps don’t adjust the suspension every time they use it and don’t mind waiting 30-40 seconds to lift or drop the vehicle.
Standard Duty OBA
Includes a low duty cycle compressor, maximum 130 PSI, small steel tank, twin-button-and-gauge controller and an OBA hook-up kit to match the compressor. Please note: The left and right air bags are independent and can be set to different pressures. Used for regular adjustment. The compressor is pre-wired with only the connections to the switching relay and three to the vehicle to be made. Four buttons allow users to lift or drop the vehicle from the control panel in a few seconds.
Recommended for: Users who regularly adjust the suspension and want to do so in a few seconds. If you have grounding issues on a motorhome then this is the controller for you. This is the minimum recommended for commercial vehicles. Ideal if you have a steep drive, problems with ferries or regularly change the weight of your vehicle.
Premium Duty OBA
Includes a 100% duty cycle compressor, maximum 200 PSI, 200 PSI tank, twin paddle/gauge controller. Used for daily adjustment. Top general spec. This is a far higher spec than the Standard Duty but essentially the same principle. Single, combined button for up and for down, and a single gauge for both left and right (twin needle).
Recommended for: Ideal control for commercial use and for motorhome users who just want the confidence from fitting the best compressor and a simpler/smarter controller. If you adjust multiple times per day then this is the ideal option.
Ultimate OBA
Includes a 100% duty cycle compressor, maximum 200 PSI, 200 PSI tank. Used for daily adjustment. Top spec, includes computer controller with programmable pre-sets and standard height adjustment for general running but can be overridden when conditions require.
This system can adjust up to four corners and, as the name suggests, is the ultimate controller. Everything is located in one integrated unit, which makes installation simple, and the remote function from any Android or Apple phone or tablet is a real bonus.
Recommended for: Users who want the best computer we offer and a remote control. Anyone who wants the best On-Board Air money can buy should go for Ultimate OBA.
If you need further clarification or your needs are not listed, please do call 0800 772 0315 or email enquiries@airide.uk and we will be very happy to help, or to raise a personal quotation.
Warranty
Airide Limited offer a warranty on Boss Air Suspension products for a period of 5 years from time of purchase. This warranty is limited to the original purchaser and subject to registration at the time of fitting. If you fail to register then a 1 year warranty is offered.
If the kit does not appear to fit – STOP and call us, as a vehicle misidentification may have occurred. Kits will be accepted for return and exchange only if they are undamaged. The buyer must cover the return postage.
Delivery
Delivery on Air Assistance kits is currently £19.95 for Mainland UK excluding Highlands. Please get in touch to find out an exact date for dispatch. We ship worldwide but our website cannot calculate international shipping costs. International customers can email their requirements to enquiries@airride.uk and we can raise an invoice including international postage. Please do call if you need more information or to know the stock situation which changes from hour to hour. Please do not assume that because you phoned last week and found it was in stock that it is still in stock.
Please note that the products listed on this site are a small proportion of those we are able to offer. If you struggle to find what you are looking for please use the search box above and if you still cannot find what you are looking for please feel free to email Enquiries@airride.uk or call
0800 772 0315
I have fitted the Boss Air suspension and it has already made a huge difference.
Mr.J.K.
I just wanted to say thank you for helping us sort out our comfort issues with the ride we get in our converted Doblo. Having the Schrader valves fitted has really made a massive difference and we can now enjoy using our vehicle and driving in style :-)
Thank you for your help and support.
Mrs.C.H.
Ordered parts, here in 2 days.
Mrs. L.W.
Had rear air suspension fitted on my Motorhome. Airide did a fantastic job, everything works and looks great. Would highly recommend using them, very professional.
Mr.M.H.
Very helpful staff.... Didn't have exactly what I wanted but I now have a better solution ... very happy
Mr.H.G.
Simple and effective. Thanks.
Mr.J.M.
Have been very helpful trying to tell me how to fit the airbag i ordered
Mr.T.
Really Responsive
Mr.J.B.
Really Responsive
Mr.J.B.
Fitted well, nice quality. And the ride is perfect.
Mr.T.S.
Returning customer to a helpful, knowledgeable and efficient small company with a good product.
Mr.B.M.
Absolutely brilliant customer service, I can't thank the guys enough for helping me, the airride system fitted to my 2018 focus st is unreall thank you again will definitely go to them in the future 😁😁
Mr.D.
Fantastic Part and exactly as described
Mr.K.D.
Excellent service, Product delivered as described and perfect for the job intended. Good people to deal with.
Mr.J.W.
Top guys who are extremely helpful.
Mr.B.R.
Really helpful, good advice given, which led to a sale for them, and now will keep them in mind for future purchases.
Mr.D.K.
The ride is so much better than before. It is even better when my wife is in the car. My wife says thank you for making her ride and life more comfortable. She is ready, she says, to go on long rides now.
Mr.L.S.
I have used the vehicle over the weekend & it is all working very well & were very pleased indeed with it.
Mr. N.
The staff from AirRide are very helpful and knowledgeable. They treat customers professionally. The order was dispatched promptly and arrived quickly. Would highly recommend to anyone I know.
Mr. E.C.
The Boss was very knowledgeable and instilled great confidence. He talked me through the process and covered all areas of concern, putting my mind very much at rest. A great job expertly done!
HHR
Top notch service and advice. Thanks for all the help.
