fbpx

Land Rover Kit | AirRide (1990 – 2016)

£2,550.00

This kit fits the classic Range Rover, Land Rover Defender (90 and 110 etc) and Discovery I and II and is a full-conversion kit, for the front and back of the vehicle. (Please let us know which when ordering as there are some dimensional differences)

It is designed by us in our Norwich workshop using the toughest bags (Australian made Boss extreme series 2500 bags) and the suspension kit is made in the UK. It is made of thicker metal and is more durable than our previous kit.

The price is for bags and brackets only. Shock absorbers are not included. The front uses standard but relocated shocks and the rear remain in the original place. Both can use some aftermarket upgraded shocks/dampers but we don’t have specific information on which combinations work.

For COIL spring vehicles only.

In stock


Please check the OPTIONS tab below (when present) for further explanation of Management options


Management (Full 4 Circuit) *

Please note that other specifications are available on request. Please contact us for a personal specific quotation.

Product price
Additional options total:
Order total:

Description

This kit is available in 2 versions: Standard and High. Standard lifts up to a maximum of 150 mm. High version lifts up to a maximum of 250 mm. Please note that these are theoretical maximums of the bag, and it is unlikely that the full potential will be achieved on all vehicles. Maximums are dictated by other factors including dampers, and wheel clearances. The high version is the default kit supplied.

Both version have the axle on the bump stop at its lowest. Both are the same price, and the higher version has a larger air volume for marginally smoother ride.

Please feel free to give us a call on 0800 772 0315 or e-mail us at enquiries@airride.uk for more information.

Options

Land Rover kits can be supplied with or without air management, although going without isn’t advisable if you have air on all four corners of your vehicle.

Air management allows you to get the very best from your kit at all times. It allows the ride height to be adjusted for road, weather and load conditions, while also giving you a street-skimming stance when the time is right.

We have four main management options for cars at AirRide. Read on to find out more:

No compressor, no tank

You can have a car kit with no air management system, but this is not recommended. With this option you will receive the air bags, brackets and struts required for a basic air suspension system, but no compressor or tank, as without some form of control system the compressor and tank would not be able to function correctly.

Manual Paddle Control (MPC)

MPC is controlled by four buttons, one for each air bag. These buttons act like electric-window switches, meaning you can either raise or lower the amount of pressure in each air bag by pressing up and down on each switch. The switches will normally fit somewhere on your dashboard.

MPC comes with an aluminium, 100% duty cycle compressor with up to 200 PSI and an air tank, so you can adjust your ride height whenever you wish (as long as it’s safe). It also comes with twin gauges and a tank gauge.

Solenoid control kit

Solenoid kits are controlled in the same way as an MPC kit, with four electric window-style buttons. However, solenoids act much faster than manual controls.

You can get either standard or advanced solenoids from AirRide. Advanced solenoids run much faster than the standard ones and can be installed a lot easier, as the come in blocks of two, rather than one.

Our solenoid kit comes with a 100% duty cycle compressor and tank for instant adjustment, as well as twin gauges and a tank gauge.

Digital computer system

The Air Lift 3P computer system electronically controls the amount of pressure in each air bag. This can be controlled either with a wired controller or a phone app. You can also set up to five pre-set heights, meaning you can slam or raise your car with just a single touch. The computer will also automatically alter your height to allow for road conditions. This is also the easiest system to install, meaning you’ll save money on installation, as compared to the MPC kit or solenoid kits.

The computer system also comes with an aluminium 100% duty cycle compressor with up to 200 PSI and an air tank, allowing for constant adjustment.

Other options

If you would prefer an air management system other to those listed, please feel free to call or e-mail us. We are happy to discuss your personal requirements and make sure you get the management system that is right for you.

Warranty

Airide Limited offers a warranty on AirRide Gold products for a period of one year from the time of purchase. This warranty is limited to the original purchaser.

If the kit does not appear to fit – STOP and call us, as a vehicle misidentification may have occurred. Kits will be accepted for return and exchange only if they are undamaged. The buyer must cover the return postage.

Delivery

Delivery for full air suspension kits is £39.95 to mainland UK excluding Highlands. Please get in touch to find out an exact date for dispatch.

We ship worldwide but our website cannot calculate international shipping costs. International customers can email their requirements to enquiries@airride.uk and we can raise an invoice including international postage.

Please do call if you need more information, or to check on stock as it can change quickly. Please do not assume that something is still in stock if you last checked on a different day to ordering.

You may also like…